Description
HP DL380p G8 Motherboard Removing
- Power down the server
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
- Remove the server from the rack
- Removes the access panel
- Remove all power supplies.
- If installed, remove the FBWC capacitor pack
- Removes the air baffle
- Remove the PCI riser cage
- Removes the fans
- Disconnect all cables connected to the system board
- Remove’s the cache module
- Removes the FlexibleLOM
- Remove’s all DIMMs
- Remove the heatsink
- Removed the processor
- Removed the failed system board.
To Replace the System Board
- Align the HP DL380p G8 Motherboard on the tray, and tighten the thumbscrew to secure it.
- Open each of the processor locking levers in the order indicated, and then open the processor retaining bracket.
- Install the processor. Verify that the processor is fully seated in the processor retaining bracket by visually inspecting the processor installation guides on either side of the processor. THE PINS ON THE SYSTEM BOARD ARE VERY FRAGILE AND EASILY DAMAGED.
- Close the processor retaining bracket. When the processor is installed properly inside the processor
- retaining bracket, the processor retaining bracket clears the flange on the front of the socket.
- Press and hold the processor retaining bracket in place, and then close each processor locking lever.
- Press only in the area indicated on the processor retaining bracket.
- Install the processor socket cover onto the processor socket of the failed system board.
- Clean the old thermal grease from the heatsink and the top of the processor with the alcohol swab.
- Allow the alcohol to evaporate before continuing.
- Apply all the grease to the top of the processor in the following pattern to ensure even distribution
- Remove the thermal interface protective cover from the heatsink
- Install the heatsink, aligning the guide pins and cutouts on the front of the heatsink
- Installs all components removed from the failed system board.
- Installs the access panel
- Slide the server into the rack.
- Connect each power cord to the server.
- Connect each power cord to the power source.
- Power up the server.
Reviews
There are no reviews yet.